What are the reasons why the piezoelectric photo machine stops working?
Many piezoelectric photo machine users in the daily use of the machine will encounter a phenomenon, the machine in the printing, the boot is normal, the start of work is normal, but the work is not long, the car will stop motionless, no matter how the operation of the machine can not run, only the re-shutdown and then boot to normal use, the photo machine appears this situation, Not only will it affect the use, but also waste the user's printing supplies. Even if it happens frequently in this situation, it will bring a lot of damage to the customer. In view of this situation, we have consulted many customers, but also asked the technician to the scene to do the test, in general, caused the photo machine to stop this failure for the following points:
First of all, because many advertising stores that use photo machines drive shops around downtown areas or some schools, which is good for the business of shops, many users do not know because the circuits used by shops in these areas are consistent with other shops or schools around them, This results in a very poor quality of the power supply used, which causes voltage instability. Before the customer reported that the photo machine is always down when the photo, there will be drip ink phenomenon, and later the technician inspection found that the power supply voltage is unstable, so that the customer installed the regulator, and then the problem is perfectly solved. Thus, the power supply problem is also a major factor in the failure of the photo machine.
For electrostatic problems, can be said to be a cliché, a lot of photo machine failure problems are actually inseparable from the reasons for electrostatic. In fact, we usually use the machine, the production of static electricity is very small, but once these static electricity is not released will form an accumulation on the machine, over time, will one day because of electrostatic problems caused damage to the machine. If the voltage formed by static electricity is too large, it will cause a short circuit of the electronic components inside the photo machine, which will cause the phenomenon of the photo machine to stop while it is working, and even more serious can cause the nozzle to burn. Therefore, regardless of the user's use of the photo machine environment, or recommended for the photo machine connected to the ground line, the export of static electricity.
Another common factor is actually caused by improper operation, we all know that the photo machine must go through the image software settings after the transmission of files to carry out printing work, some novice users do not know much about the use of software, arbitrary settings for the software, resulting in the photo machine can not work. There is also to note that the photo machine with the genuine output software in different computers to set up is not the same, if the user does not understand, you can consult the photo machine manufacturers, please manufacturers of technicians remote Guidance installation settings, to avoid human failure factors.
The configuration of the photo machine in the factory is generally set by the manufacturer testing, there are many novice users because they do not understand the technology, so after receiving the machine out of curiosity and casually change the system settings of the photo machine, it is easy to cause the photo machine can not work failure. After receiving the machine issued by the manufacturer, it is best to set the parameters of the photo machine under the guidance of the technician, not to change at will, so as not to bring trouble to the manufacturers, but also to cause losses to themselves.
