The nozzle of the UV tablet is not only a component of the device but also a type of consumable in the entire printing. When the nozzle of the UV tablet reaches a certain service life, it needs to be replaced. However, the nozzle itself is delicate, and improper operation will cause problems in the printer nozzle, and even more serious, even scrapped, so be extremely cautious.
The UV flatbed printer nozzle installation steps are divided into the following steps:
1: First of all, ensure that the UV flatbed printer is working properly, the ground connection of the machine is normal, and the voltage supplied by the nozzle is normal! You can use a meter to test the main components of the machine for static electricity.
2: Secondly, use software to test whether the UV flatbed printer is working normally, whether the raster reading is normal, and whether the indicator light is normal! The operator's hand should not have sweat or moisture, because touching the nozzle line plug once it is inserted into the nozzle may cause the nozzle to short circuit.
3: Check whether the data plug of the UV flatbed printer has a raised pin. Is it flat? It is better to use a new plug wire and insert the plug wire into the nozzle. Do not insert any tilt. The head line scale of the nozzle line is generally divided into two sides, one side is in contact with the circuit, the other side is not in contact with the circuit, and the direction is not wrong. After inserting it, it must be checked several times to confirm that there is no problem in installing the nozzle on the small frame.
4: After the UV flatbed printer head is fully installed, check it three to five times. After confirming that there is no problem, turn on the power. It is best not to open the nozzle first. First, use the ink pump to draw the ink, then turn on the nozzle power. First check if the flashing is normal. The flashing is normal and the installation is successful. If the flash is not normal, please turn off the power immediately and check if there is something wrong.
