The reason why the photo machine nozzle does not ink
Ink breaking, ink can be considered to be a photo machine nozzle blockage. The nozzle is the most precious, the most accurate and the most powerful component in the parts of the photo machine. It is also known that nozzles are easy to block and that users familiar with the device may be simply adjusted or repaired, but it is a particularly tricky issue for new operators. What causes the photo machine nozzle blockage? Here's a brief summary of the causes of nozzle blockage?
A:The working environment of the photo machine, the indoor temperature of the work, the humidity of the air, etc., will also easily cause the nozzle blockage, so, winter and summer such a temperature conditions, should be better focus on the daily maintenance of the photo machine, such as, summer, indoor operating temperature is too high, winter temperature is too low, and different humidity and other changes, Usually in this case, we recommend that the photo machine working room temperature between 22 degrees to 25 degrees, not too high or too low, the relative humidity is best at about 40% to 70%.
B.Ink viscosity problems, for example, ink in the nozzle outside the accumulation of too much to a certain extent will clog the nozzle, which is the most common situation, but also caused by the nozzle blockage one of the reasons. The reason is not much here, I believe we all understand. There is also related to the viscosity of the ink, ink viscosity is too high or too low will cause the photo machine nozzle blockage, ink viscosity is too high will make ink fluidity is poor, ink viscosity is too low easy in the spray when the piezoelectric crystal back pumping when inhaling air, can not suck ink, spewing out is air, that is, our common ink breaking phenomenon, So both will cause the nozzle to clog up
C.Piezoelectric crystal problem, if the piezoelectric crystal is broken (the general piezoelectric nozzle service life of about a year, this according to the use of the nozzle) in this case, the nozzle is completely not out of ink, rather than the nozzle blockage problem.
D.The use of different ink, due to different manufacturers of different ink composition, in the replacement of ink to the nozzle and pipe thorough cleaning, because the original ink and the replacement of ink mixed with each other, will form ink in the reaction of different chemical components caused by the blockage of the photo machine nozzle.
E.Other factors, such as the photo machine does not pay attention to maintenance, equipment on the dust too much, oil and so on, resulting in the photo machine nozzle spray ink phenomenon.
